STpad EN Getting started
© Atlas Copco Industrial Technique AB - 9839 0882 01
15
■
Use only the included digitizer to touch the screen. Do not place any objects on its surface and do not
press down strongly with sharp-pointed or hard objects that may leave marks (e.g. nails, pencils and
ball point pens).
■
Use the digitizer only for touching the screen. Using it for any other purpose may damage the digitizer
and result in scratches on the screen.
■
The digitizer uses electromagnetic induction and may not work properly near strong electrical field or
magnetic field such as:
■
AM radio base stations or relay station antennas;
■
CRT displays that generate strong electromagnetic field noise.
Move the digitizer away from such locations so it works correctly.
■
The pointer cannot follow the digitizer movement if these are too quick
To make a selection, tap the screen once with the digitizer. To double-click, tap twice without pausing. To
do a right-click, tap the screen once and hold the tip of the digitizer on the screen, the right-click icon ap-
pears. Press the click button is the same as a right click.
Removing the protective film from the display
The front display of the STpad is protected during transport by a transparent film. This film should remain
on the front display during assembly to avoid damage to the front display surface. Remove the film only
once the assembly work has been completed.
To Next Page
Loading...