Atlas Copco STpad - Removing the Battery

Operation EN STpad
24
© Atlas Copco Industrial Technique AB - 9839 0882 01
2. Put the battery.
1 Locking switch 2 Release button 3 Battery
3. Align the poles on the battery with the slots on the chassis.
4. Angle the battery in place and set the poles in the chassis slots.
5. Lower the raised end of the battery and press in place until an audible click is heard.
6. Slide the locking switch on the top-left side to lock the battery.
Make sure that the latch is securely locked to prevent the battery from falling.
Removing the battery
1. Put the device display side down on a clean work surface.
2. Put the battery.
1 Locking switch 2 Release button 3 Battery