Getting started EN STpad
10
© Atlas Copco Industrial Technique AB - 9839 0882 01
Getting started
Introduction
This section provides an outline of the steps necessary to setup a new STpad. A detailed guide follows the
listed items, see as follows.
For additional technical assistance, contact your local Atlas Copco Customer Center.
It is recommended to install or remove accessories on a clean, well-lit work surface. To protect your-
self and the device from electrostatic discharge, wear anti-static wrist straps or place the device on
an anti-static mat.
Using for the first time
1. Open the left I/O compartment cover (for more information, see “Opening I/O compartment cover” ).
2. Switch the battery switch to the ON position.
3. Close the left I/O compartment cover (see the paragraph “Closing I/O compartment cover” for more
information).
See also
2 Opening I/O compartment cover [16]
Charging the battery
After connecting the STpad to a power outlet through a standard AC adapter, the standard and external
(optional) battery recharge automatically.
During the charging process, the power LED is on.
When the battery is fully charged, the power LED is lit with a solid green.
1. Flip open the DC-IN cover to expose the DC-IN jack.
To Next Page
Loading...