Atlas Copco STpad - Installing the Battery

STpad EN Operation
© Atlas Copco Industrial Technique AB - 9839 0882 01
23
1 Metal loop
Removing the Shoulder Strap
1. Press in the clips to release them from the metal loop.
2. Remove the clips.
1 Metal loop
Installing the battery
The following instructions are for both standard and external batteries. The external battery is an optional
component. Use only components specifically designed for this device. Contact your local representative
for ordering information.
Make sure that the power switch is switched to ON before installing the standard/external battery
(see the paragraph “First time use” for more information).
1. Put the device display side down on a clean work surface.