Atlas Copco STpad - Removing the Microsd Card; Using the Digitizer

Getting started EN STpad
14
© Atlas Copco Industrial Technique AB - 9839 0882 01
4. Insert the micro SD card and press it in until an audible click sounds.
5. Close the left I/O compartment cover (for more information, see “Closing I/O compartment cover”).
See also
2 Opening I/O compartment cover [16]
2 Closing I/O compartment cover [17]
Removing the Micro SD card
1. Open the left I/O compartment cover (for more information, see “Opening I/O compartment cover”).
2. Put the micro SD slot in the left I/O parts.
Left view: Micro SD Slot
1 Micro SD Slot
3. Press the micro SD card in and release it. The card springs out.
4. Hold the micro SD card and remove it from the slot.
5. Close the left I/O compartment cover (for more information, see “Closing I/O compartment cover”).
See also
2 Opening I/O compartment cover [16]
2 Closing I/O compartment cover [17]
Using the digitizer
Below are the information when using a digitizer: