420
7679H–CAN–08/08
AT90CAN32/64/128
34. Datasheet Revision History for AT90CAN32/64/128
Please note that the page numbers in this section refer to this document.
The revision noted in this section refer to the document revision.
34.1 Changes from 7679G - 03/08 to 7679H - 08/08
1. Minor corrections throughout the document.
34.2 Changes from 7679F - 11/07 to 7679G - 03/08
1. Added errata problem 8 on 416.
34.3 Changes from 7679E - 07/07 to 7679F - 11/07
1. Updated “Errata” on page 416.
2. Updated “Bit 0 – SMP: Sample Point(s)” on page 259 in Section “CAN Register
Description”
34.4 Changes from 7679D - 02/07 to 7679E - 07/07
1. More details on CANSTMOB register. Section 19.11.1 on page 261.
2. Update to Ordering information, product marking. Section 32. on page 412.
34.5 Changes from 7679C - 01/07 to 7679D - 02/07
1. Modified DC Characteristics - Icc Active & Idle modes. Section 26.2 on page 366.
2. Removed “SPI programming timing” errata and replaced by the note in the 4
th
step of
“SPI Serial Programming” on page 349.
3. Updated “Bit 1 – ENA/STB: Enable / Standby Mode” on page 252 in Section “CAN Reg-
ister Description”
4. Updated POR characteristics in Table 7-1 on page 52.
5. Updated “Phase Correct PWM Mode” on page 153.
6. Updated SPI Features . Section 16.1 on page 168.
7. Updated “Errata” on page 416.
34.6 Changes from 7679B - 11/06 to 7679C - 01/07
1. Modified QFN64 package drawing. Section 32.2 on page 414 and Section 32. on page
412.
34.7 Changes from 7679A - 10/06 to 7679B - 11/06
1. CAN Sampling point position when the prescaler is bypassed in Section 19.4.3 ”Baud
Rate” on page 242 and update of Table 19-2 on page 267.
34.8 Document Creation
1. 7679A - 10/06
To Next Page
Loading...
Need help?
General
