31
Reprocessing
5. Remove the attachment for pressure compensation and the protection cap
on the USB connector. Before use, check that there is no moisture on the USB
connector.
6. Move the deection lever several times and check that it moves easily and that
the distal end moves properly.
7. Check the ATMOS Scope for leak tightness using the manual leakage tester (see
chapter “3.6.2 Performing a leakage test” on page 22).
8. Check whether an image is displayed and the LED lamp is turned on.
5.3 Preparing surfaces
5.3.1 Overview
Surface
After each patient
Pre-treatment
Pre-cleaning
Manual cleaning and
immersion disinfection
Mechanical cleaning and
disinfection
Sterilization
Drying with cloth
Remarks
To Next Page
Loading...
