Atom HSP588 - Page 28

HSP588
Use and maintenance manual pag. 28
d) simultaneously press the synchronized pushbuttons (L): the striking plate will move downward till
gently coming into contact with the cutting die (Fig. 6)
e) unloosen and immediately lock the cutting stroke-end positioning hand-wheel (N) (Fig. 7).
f) slowly turn counter clockwise the handwheel (V) till the daylight between striking plate and cutting-
die is the wished one, keeping in mind also the thickness of the material to be cut; turn again clockwise the
handwheel up to its highest limit (Fig. 8)
Fig. 8
(V)(V)
Fig. 7
(N)
Fig. 6
(L)
(L)