Shenzhen AtomStack Technologies Co., Ltd. support@atomstack3d.com
engraving machine, Befon A5 PRO+ engraver uses rectangular spot for
0.23*0.23mm, the core energy area of the spot size is about 0.08*0.15mm,
Therefore, it is recommended to use an engraving quality of 8, The
response to laser illumination varies from different materials, so the exact
value depends on the specific engraving material.
d. at the bottom of the preview window, the image can also be rotated,
mirror, cut, etc. operations.
e. After completing the above settings, click next to the the settings of
carving speed, carving energy and carving size.
Picture 3.9 Introduction of Setup Interface
C. Engraving speed, engraving energy and engraving size Setting
a. recommending the engraving speed for 3000, this is the best value
for the engraving effect after repeated experiments, of course you can
increase or decrease the speed according to your preference, faster speed
will save the engraving time, but it may reduce the engraving effect,
slower speed is the opposite.
To Next Page
Loading...
Need help?
General
