Atrust t68WD - Resetting Your T68 Wd

123
A.1 Resetting Your t68WD
Reset Mode enables you to restore settings under Atrust Client Setup to the factory defaults. Additionally, it also
releases a managed t68WD from the management of Atrust Device Manager, a management console developed by
Atrust for remote and mass client management.
You can perform Reset Mode locally through Atrust Thin Client Menu.
NOTE
• You can also release a managed t68WD remotely from Atrust Device Manager.
For details, please refer to the User’s Manual for Atrust Device Manager.
To reset your t68WD, please do the following:
1. Restart your t68WD.
2. During the POST (Power-On Self-Test) period, press Esc on the keyboard to enter Atrust Thin Client Menu.
Atrust Thin Client Menu
Normal boot
Reset Mode
Firmware Update
Reboot
Shutdown
NOTE
• Five options are available on Atrust Thin Client Menu: Normal boot, Reset Mode,
Firmware Update, Reboot, and Shutdown. See the table below for the
description of each option:
Menu Option Description
Normal boot Powers up your t68WD as the normal startup procedure.
Reset Mode
Resets Atrust Client Setup settings and remote management
status for your t68WD.
Firmware Update Updates rmware for your t68WD through the network.
Reboot Restarts your t68WD.
Shutdown Powers off your t68WD.
3. Use arrow keys to select Reset Mode, and then press Enter to continue.
4. A message appears prompting you for conrmation. Type y to conrm.
5. Upon completion, press Enter to restart.