ALL
17
“LUBE” will be displayed on the digital screen when the accumulated hour reaches 100
hours or distance of 1000km as a reminder of belt maintenance. Please press “STOP” or
remove the safety switch and maintain the belt under standby status. Aer finishing belt
maintenance, please press “START”, “SPEED UP” and “SPEED DOWN” simultaneously to
clear the accumulated hours or kilometers. For belt maintenance, apply the silicon oil
(the whole bole) to the inner side of belt. Aer the oil is fully applied to the belt, please
operate with high speed (10KM) for 10 minutes to make the oil spread evenly on the belt.
The belt slides to the le:
When the belt slides to the le, please fine-tune
the rear le screw in a clockwise direcon to the
right under high speed operaon (10KM). Repeat
above steps unl the belt moves back to the
center if the belt sll shis off aer 30~60 seconds
under high speed operaon.
The belt slides to the right
When the belt slides to the right, please fine-tune
the rear right screw in a clockwise direcon to the
right under high speed operaon (10KM). Repeat
above steps unl the belt moves back to the
center if the belt sll shis off aer 30~60 seconds
under high speed operaon.
The posion of belt is adjusted before shipment. However, somemes the belt may shi off center during transportaon.
To adjust a slipping belt, please use the enclosed hex wrench turn the screws at rear (both sides) of the deck to the right by 90 degrees unl no slippage occurs.
Make sure the belt is not moving while adjusng the screw.
DO NOT adjust the belt when the machine is operang. A ght belt may bring extra load to the frame and electronic components and
To Next Page