ALL
37
Pairing of Various Devices
Please set in PROGRAMS when you want the machine to calculate the exercise data based on personal parameters. Or you can enable the
Please set in PROGRAMS when you want the machine to calculate the exercise data based on personal parameters. Or you can enable the
App. Input your personal parameters in the APP and press “
App. Input your personal parameters in the APP and press “
,and the treadmill will calculate the exercise data based on personal
,and the treadmill will calculate the exercise data based on personal
1) The treadmill can only pair and connect to ONE smart device when operang. Please pair and connect to the treadmill via the APP on the smart device.
2) Once the APP or Bluetooth is disabled, the smart device will be disconnected from the treadmill.
3) You can set personal parameters on the APP and press “START” on the smart device screen; the treadmill will start calculang according to your personal
parameters.
Mobile phone connecon
If your wearable provides 5 kHz signal, you’ll see your heart rate aer standing near the treadmill aer 5 to 10 seconds.
To display the 5 kHz heart rate, you need to disable the display funcon of Bluetooth & ANT+. When the indicator of Bluetooth & ANT+ is off
To display the 5 kHz heart rate, you need to disable the display funcon of Bluetooth & ANT+. When the indicator of Bluetooth & ANT+ is off
on the console display overview, the heart rate at this me is the detected value of 5 kHz heart rate.
on the console display overview, the heart rate at this me is the detected value of 5 kHz heart rate.
5 kHz connecon
How to pair and connect your wearable through Bluetooth/ANT+ connecon:
1) Press the buon of Bluetooth/ANT+ on the operang panel for about three seconds unl the beep is sounded.
2) The pairing takes 40~60 seconds. The indicator of Bluetooth/ANT+ will blink when pairing; you can see the heart rate on the console display overview aer
pairing is completed.
3) You may simultaneously pair Bluetooth & ANT+; simply select the available pairing method of Bluetooth or ANT+ from the operang panel.
The pairing process will be stopped if the Bluetooth or ANT+ buon on operang panel is pressed. If you wish to use wearables again,
The pairing process will be stopped if the Bluetooth or ANT+ buon on operang panel is pressed. If you wish to use wearables again,
simply pair through via long press.
simply pair through via long press.
In general, device pairing takes 40~60 seconds. Please check if there is any noise interference in surroundings when the pairing takes too
In general, device pairing takes 40~60 seconds. Please check if there is any noise interference in surroundings when the pairing takes too
long. It is recommended to disable other Bluetooth/ANT+ devices and press the pairing buon for another pairing.
long. It is recommended to disable other Bluetooth/ANT+ devices and press the pairing buon for another pairing.
•
•
To Next Page