Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.15 - Control unit release
Note:
New/old dash panel inserts or old engine control unit must always be released.
Requirements:
• Vehicle diagnostic, testing and information system VAS 5051 connected up and vehicle self-diagnosis se‐
lected => Page 162
• Ignition on
Sequence of operations
- Establish immobilizer identification number by starting self-diagnosis for appropriate control unit (engine or
immobilizer).
- On the basis of the 14-digit immobilizer identification number, request 7-digit PIN from appropriate Sales
Centre/importer.
Note:
The PIN is only valid for one day, after which a new number has to be requested. The PIN is of no use to the
customer or other dealerships.
-> Readout on VAS 5051:
- From list -1- select diagnostic function "Release (PIN)".
▼ Readout on VAS 5051
Vehicle self-diagnosis 17 - Dash panel insert
8L0919860A
Function test
DASH PANEL INSERT+IMMOBILIZER VDO D06
Channel 50 adaption (PIN)
Code 00142
Dealership number 12345
Information
PIN is used for release of Done
key matching/adaption in
Vehicle system
PIN provided on the basis of
immobilizer identification number
is only valid
for one day
Audi A8 1994 ➤
Electrical system Self-diagnosis 02.99 ➤ - Edition 05.2002
104 01 - Self-diagnosis
To Next Page
Loading...
