Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Sequence of operations
After fault memory interrogation:
-> Readout on VAS 5051:
- From list -1- select diagnostic function "05 - Erase fault memory".
-> Readout on VAS 5051:
1 - - No readout (prior to erasing)
Or
-Fault memory erased
Note:
If the following message appears in display zone -1-: "Fault memory not yet interrogated", this means that
sequence of operations has not been precisely observed. Fault memory cannot be erased until it has been
interrogated.
2 - Note:
Is function to be implemented?
Note: Data will be erased!
- Touch "OK" key on display -2-.
- Terminate function "05 - Erase fault memory" by touching ◂ key.
- Interrogate fault memory again after performing repair work.
Note:
This erases faults stored during fault elimination e.g. on account of connectors being unplugged.
4.8 - End output
Audi A8 1994 ➤
Electrical system Self-diagnosis 02.99 ➤ - Edition 05.2002
4.7 - Erase fault memory 129
To Next Page
Loading...
