Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Display data bus control units- Adaption value
Dash panel insert, navigation system
RNS-D and telematics with multi-func‐
tion steering wheel
15
- Change adaption value by means of direct entry => "B - Changing adaption value by means of direct entry",
Page 32 .
- Enter 5-digit adaption value. Use "0" to fill up blanks.
Example:
Desired input: 5
Dash panel insert, radio and navigation
Keypad entry: 00005
-> Readout on VAS 5051 following adaption:
Example:
1 - Channel 62
Value 5 saved
- Terminate function "10 - Adaption" by touching ◂ key.
1.16 - Input values on dash panel insert replacement
The following items must always be observed on replacing dash panel insert:
Perform the following before replacing dash panel insert:
- Use measured value blocks 010...140 to read out values in old dash panel insert which have to be transferred
to new dash panel insert.
- Before replacing, note down mileage count/mileage display value in measured value block 010 (display zone
4) => Page 23 and enter when prompted.
Note:
Service display and mileage counter are adapted in miles in countries wheredistances are measured in miles.
Perform the following after replacing dash panel insert:
- Code dash panel insert => Page 17
and
Audi A8 1994 ➤
Electrical system Self-diagnosis 02.99 ➤ - Edition 05.2002
1.15 - Adaption channels 60 to 62 67
To Next Page
Loading...
