Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.15 - Adaption channels 60 to 62
Adaption channel 60 - control units using drive train data bus
This function can be used to enter control units using drive train data bus on dash panel insert replacement.
-> Readout on VAS 5051:
1 - Enter channel number
- Use keypad -2- to enter "60" for "Adaption channel 60" and confirm by touching Q key.
-> Readout on VAS 5051:
1 - Channel 60
Read and test
4 - Slide bar positioned on current adaption value
Notes:
◆ Current adaption value for channel 60 can be read out as of model year 2002 in measured value block 017
=> Page 26 .
◆ Following adaption, control units using drive train data bus are displayed in measured value block 125
=>Page 27 .- Dash panel insert is not displayed in measured value block 125.
◆ Dash panel insert replacement => Page 67 .
Control units using drive train data bus are adapted by entering the following values:
Drive train data bus control units Adaption value
Engine and dash panel insert with im‐
mobilizer II
0
Audi A8 1994 ➤
Electrical system Self-diagnosis 02.99 ➤ - Edition 05.2002
62 01 - Self-diagnosis
To Next Page
Loading...
