Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.6 - Final control diagnosis
Notes:
◆ Final control diagnosis can only be performed with engine stopped and ignition switched on.
◆ If final control diagnosis detects a fault, locate and eliminate cause of problem.
"Final control diagnosis" function consecutively actuates the following dash panel insert control elements (if
fitted/coded):
Actuation sequence
1 Analog displays
2 Dash panel insert warning lamp test
3 Seat belt warning system warning lamp -K19
4 Gong
5 Segment test
6 Illumination/switches and instruments
Test requirement:
• Illumination on
Sequence of operations
- Start dash panel insert self-diagnosis => Page 2 .
-> Readout on VAS 5051:
- From list -1- select diagnostic function "03 - Final control diagnosis".
Audi A8 1994 ➤
Electrical system Self-diagnosis 02.99 ➤ - Edition 05.2002
12 01 - Self-diagnosis
To Next Page
Loading...
