Audi A8 1994 - Resetting Service Display on Completion of Service Work (Without VAS 5051)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
- Enter mileage => Page 38
- Enter language version for driver information system (DIS)
=> Page 37
- Correct fuel consumption indicator => Page 36 (only if fixed value changed)
- Correct fuel gauge sender resistance range => Page 45
(only if fixed value changed)
- Auxiliary heater adaption=> Page 42
- Enter oil grade => Page 56
- Enter mileage since service => Page 48
- Enter days since service => Page 49
- Enter maximum mileage prior to service => Page 52
- Enter maximum time interval prior to service => Page 54
- Enter total consumption (petrol engines only) => Page 58
- Enter amount of soot in engine oil (diesel engines only)
=> Page 59
- Enter thermal load (diesel engines only) => Page 60
- Configure radio clock/dash panel insert illumination => Page 43 .
- Enter control units using drive train data bus => Page 62
- Enter control units using convenience system data bus
=> Page 63
- Enter control units using display data bus => Page 65 -
and
- Perform immobilizer adaption after replacing dash panel insert
=> Page 91
- Perform matching of vehicle keys => Page 01-180
1.17 - Resetting service display on completion of service work (without VAS 5051)
Attention:
Resetting without V.A.G 5051 automatically sets service to a fixed interval.
Service prompt must be reset after performing service.
Service display should only be reset using "Adaption" function of vehicle diagnostic, testing and information
system VAS 5051=>Page 34 .
The service display can also be reset as follows:
- Switch off ignition.
- Press and hold reset button for trip counter in dash panel insert.
- Switch on ignition whilst pressing button.
- Release button.
"SERVICE!" is displayed after releasing trip recorder button.
- Press clock adjuster knob in dash panel insert within 5 seconds until message is reset to "SERVICE IN
15000 KM".
- Switch off ignition.
Notes:
◆ Channels 40, 41, 46, 47 and 48, which display dynamic service values, are set automatically to "0".
◆ Resetting without VAS 5051 automatically sets service to a fixed interval (see table).
Channel 42 (min. mileage) 15,000 km
Channel 43 (max. mileage) 15,000 km
Channel 44 (max. time interval prior to
service)
365 days
Audi A8 1994 ➤
Electrical system Self-diagnosis 02.99 ➤ - Edition 05.2002
68 01 - Self-diagnosis