Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
-> Readout on VAS 5051:
1 - Channel 19
Read and test
4 - Slide bar positioned on current adaption value
Notes:
◆ Current adaption value for channel 19 can be read out as of model year 2002 in measured value block 019
=> Page 26 .
◆ Dash panel insert replacement => Page 67 .
The radio clock display is adapted by the following input:
Radio clock
X X X X 0 No radio clock
X X X X 1 With radio clock
Instrument illumination function can be adapted as of model year 2002 by entering the following values:
Instrument illumination
0 X X X X Pointers and scales light with dipped beam
"on"
1 X X X X Pointers light with ignition "on", scales light
with dipped beam "on"
2 X X X X Scales light with ignition "on", pointers light
with dipped beam "on"
3 X X X X Pointers and scales light with ignition "on"
- Change adaption value by means of direct entry => "B - Changing adaption value by means of direct entry",
Page 32 .
- Enter 5-digit adaption value. Use "0" to fill up blanks.
Example:
Desired input: 10001 for instrument illumination and radio clock
Keypad entry: 10001
Note:
Fault message "Function unknown or cannot be implemented at present" appears if an implausible value is
entered.
-> Readout on VAS 5051 following adaption:
Audi A8 1994 ➤
Electrical system Self-diagnosis 02.99 ➤ - Edition 05.2002
44 01 - Self-diagnosis
To Next Page
Loading...
