EasyManua.ls Logo

Audi A8 2014 - Page 106

Audi A8 2014
314 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
104 Aud i la n e ass is t
- The curve is too sharp.
(1_) Tips
Make sure the camera's fie ld of view
c::> fig. 105 is not obstr ucted by st ickers,
deposits or anything else. For inf ormation
on cleaning, refer to
c::;, page 216 .
Lane assist display in the instrument
cluster
Applies to vehicles: with la ne ass ist
Fig. 106 Instrument cluster: lane assist is switched on
and is warning
Fig. 107 Instrument cluste r: lane assist is switched on
but not ready to provide warnings
You can call up the lane assist display using
the buttons in the mult ifunction steering
wheel
c::> page 24.
When lane assist is switched on, the system
indicates which lin es are detected by display-
ing solid lines on the left and/or right side of
your vehicle:
Wh ite line(s) Lane assist is switched on and
ready to provide warnings on
the side that is indicated
<=:>fig . 106.
Red line Lane assist is warning you
(left or rig ht) that you are about to leave
your lane
c::;, fig . 106 .
Gray line(s)
Lane assist is switched on but
is not ready to provide warn-
ings
c::;, fig. 107.
Messages in t he instrum ent cluster
di splay
When the lane assist turns off automatically,
the instrument cluster indicator goes out and
one of the follow ing messages appears on the
display:
Audi lane assist: current ly unavailable. No
camera view
This message appears if the camera is no lon-
ger functional after the system has continu-
ously failed to detect the lane markings. This
could happen if :
-The camera field of view
c::;,page 103,
fig . 105 is dirty or covered in ice. Clean the
area on the windshield.
- The camera field of view is fogged over. Wait
until the fog has cleared before switching
lane assist on .
- The system has been unable to detect the
lanes for an extended period of ti me due to
road conditions such as lanes covered in
snow. Switch lane assist back on when the
lines are more visible.
Audi lane assist: Currently unavailabl e
A temporary malfunction is preventing lane
assist from operating. Try switching lane as-
sist on again later.
Audi lane assist: Syst em fault !
Drive to your author ized Audi dealer soon to
have the malfunct ion corrected.

Table of Contents