Setting the warning point and steering
wheel vibration
Applies to vehicles: with lane assist
You can adjust individual settings in the MMI.
.. Select : I CARI funct ion button > Car systems
control button > Driver assist > Audi lane
assist.
Setting the warning point
Early:
With this setting, a warning is provided
before a wheel touches the detected lane
boundary line. The warning depends on the
angle in which the ve hicle is approaching the
line. The distance at which the warning is giv-
e n increases as the angle becomes sharpe r. If
you dr ive toward a bounda ry line at a very
sha rp angle, the warning will come just before
a wheel touches the line.
Medium: With th is sett ing, the warning point
is adapted to the cou rse of the road, the lane
width and the speed . You will st ill be warned
if you cross slightly over a dotted line when
driving on curves.
Late: This setting has the same properties as
medium. You will only be warned once a
wheel crosses a detected line.
Setting the steering wheel vibration
The stee ring wheel vibration can be set to
Low, Medium or Strong. Selecting each of the
set ti ngs will cause the steering wheel to vi-
brate so you can check the strength of the vi-
bration in that setting.
@ Tips
Your settings are automatically stored and
assigned to the remote contro l key be ing
used.
Audi lane assist 105
To Next Page
Loading...
