lL
t:0
....
"'
......
"'
....
0
0
:c
'<I"
Labeling th e wirele ss headphone s
- Attach the supplied label CD or @ ¢ fig. 208 on
the inside of t he left /right wire less head -
phones .
Labeling the wireless headphones:
CD Wireless headphones label (paired with the
left RSE disp lay)
@ Wireless headphones labe l (paired with the
right RSE display)
Switching wireless headphones on/ off
- Swit ching on : to sw itch the wireless head-
phones on, press the On/ Off button <!) CD
¢
fig. 207 on the right earp iece (R) for approxi-
mately
3 seconds and release it once the LED
@ starts blinking. The light @ will blink slowly
once the connection to the wireless head-
phones has been established .
- Switching off : to switch the wireless head -
phones off, press and hold the On/Off button <!)
CD until the LED@ turns off.
The wireless headphones switch off automatical-
ly about five minutes after the RSE switches off .
Disconnect wireless headphones
You can delete the pairing between the wireless
headphones and t he RSE if you need to switch
out the headphones o r change the pairing.
- Select :
IM ENU I button > Setup RSE cont rol but-
ton > Head set > Delet e wirele ss headset .
& WARNING
- For safety reasons, as the dr iver, only use
the headphones when the vehicle is station-
ary to reduce the risk of a crash.
- When driving, store the headphones secure -
ly so that they do not move around in the
vehicle interior when bra king or in a crash .
- Maintai n a mode rate volume leve l when lis-
tening to audio playback through the head-
phones. Continuo us expos ure to extreme
volume levels may result in loss of hear ing.
(D Tips
- If the wireless headphones were already
paired, the connection to the headphones
-
Rear Seat Entertainment
will be reestablished after switc hing the
RSE on if the headphones are switched on.
- The RSE on ly supports wireless headphones
from an authorized Audi dealer .
- Audio/video output through the wire less
headphones stops during the pai ring proc-
ess.
- The pairing process must be done separate-
ly for the left and right wireless head -
phones. The wire less headphones are as-
signed to the left or right RSE display de-
pending on the side of the RSE control unit
where you started the pairing process . The
pairing between the wireless headp hones
and the left/right RSE display is ident ified
with a label.
- Volume that is too high or too low is auto-
matically adjusted to a preset leve l when
the wireless headphones are connected .
Charging and changing the battery
Applies to: vehicles with Rear Seat Entertainment
If the light on the wireless headphones turns
red, the batteries are low and need to be charg-
ed or replaced.
Fig. 209 Conn ectio n for th e charg ing cab le/ battery com-
part me nt
- Charging the battery : connect the charging ca-
ble to t he connection CD¢ fig. 209 on the bot -
t om side of the left ea rpiece (L). Then con nect
the charging cable to the cigarette lighter */12
Volt socket* in the rear center console.
Or :
charge the battery for the wireless headp hones
with the min i USB adapter cable th rough the
Aud i mus ic interface ¢ page 186.
- Changing th e batterie s: turn the cover @
¢
fig. 209 on the left earpiece (L) to the left/ IJI,,-
199
To Next Page
Loading...
