Re ar Seat Ent e rtainm e nt
right and change the batteries as labeled in the
battery compartm ent . Then attach the cover
back on to the left earpiece
(L).
You can ident ify t he charge status of the battery
q table on page 200 based on the blinking
speed of the LED in the charging cable conn ec-
tion
CD q fig. 209.
Blinking fre- Charge status
quency
Blinking The batteries are cha rging.
Rema ins on The batte ries are charged .
Blinking An error occurred while charg-
quickly ing.
A WARNING
- Do not use damaged rechargeable batteries .
This increases the risk of an explos ion.
- The headphones can become warm when
the batteries a re charg ing and increase the
risk of injury.
- Do not charge standard batteries with the
charg ing cable. This increases t he risk of an
exp losion .
- Be careful when using the cigarette lighter .
Inattentive or unsupe rvised use of the ciga-
rette lighte r can cause burns.
- The ciga rette lighter/sockets and any elec-
t rical accessor ies connected to t hem func-
t ion only whe n the ign ition is sw itched on.
Using the ciga rette lighter/sockets or elec -
trical accessories incorrect ly can lead to se -
rious injuries or cause a fire. To reduce the
risk of inju ries, never leave children unat-
tended in the vehicle with the vehicle key.
@ Note
- Do not charge the batteries in the wireless
headphones when the engine is not run -
ning . This will dra in the vehicle battery .
- For wireless headphones, on ly use batteries
that are approved for that type of device,
for example NiMH batteries with a mini-
mum capacity of 550 mAh in AAA size that
are suitable for quick charging .
200
@ For the sake of the environment
Batteries contain po lluting substances. They
must be disposed of us ing methods that w ill
not harm the env ironment. Do not dispose of
them in househo ld trash.
(D Tips
The charging time for t he included rechargea-
ble batter ies is approximate ly three to four
hours and may increase by approximately 25
percent if the batter ies are in use while charg-
ing .
Headphones connected by cable
Appli es to: vehicles with Rear Seat Entertainment
The headphone connections are located on the
RSE control unit.
Fig. 21 0 Connect ing wir ed headpho nes
.,. Insert t he headphone connecto r into t he left or
right jack
CD q fig. 210 on the RSE control pan -
el.
The uni t is eq uipped w ith 3.5 mm stereo jacks .
The w ireless headphones sw itch off automat ical-
ly about five minutes after the cable headphones
a re connected.
(D Tips
Volume that is too h igh or too low is auto-
mat ically adjusted to a preset level whe n the
wired headphones are connected.
To Next Page
Loading...
