Audi Q3 2024 - Page 131

83A0127218K
Driver assistance
Predictive control
Applies to: vehicles with adaptive cruise assist and predictive
control
General information
With predictive control, efficiency assist adapts
the speed set in the adaptive cruise control @)
<page 125, fig. 99 based on detected speed lim-
its and the upcoming route. Once the system no
longer detects any relevant conditions ahead,
adaptive cruise control will accelerate back up to
the last speed set by yourself. After switching on
the ignition, the availability of predictive control
is indicated by a message when the adaptive
cruise assist is first activated.
Incident symbols indicate the situation to which
predictive control is reacting.
Requirements
~The predictive control is turned on in the Driver
assistance menu under Adaptive cruise assist
page 117.
~The adaptive cruise assist must be actively reg-
ulating > page 126.
~The system can only react to speed limits that
are 15 mph (20 km/h) or higher.
~The map content of the navigation system*
must be updated regularly in order for the sys-
tem to work without restrictions page 182.
Overriding control
You can override the predictive control at any
time by pressing the accelerator pedal. If the sys-
tem changes the vehicle speed to adapt to speed
limits, you can change the speed using the lever
page 126, fig. 102.
Situation symbols
Depending on vehicle equipment, the following
symbols may be shown. The symbols indicate the
situation to which the predictive control is re-
sponding. Some detail symbols will only be dis-
played in the Driver assistance display.
Symbol |Description
Speed limit
(example)
Speed limit
Speed limit
Speed limit removed
Exit ahead
Intersection ahead
Traffic circle ahead
Messages
and a message with Predictive control is
displayed when there is a malfunction, the effi-
ciency assist functions are unavailable or limited
A message that indicates the cause and possible
solution may appear with some displays. The
weather conditions may be too poor or a sensor
may be covered. Clean the area in front of the
sensors ® page 176 and try to turn the system on
again later.
If the malfunction remains, drive to an author-
ized Audi dealer or authorized Audi Service Faci
ty immediately to have the malfunction correct-
ed.
_ WARNING
— Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras > page 114 to > page 117.
— Pay attention to traffic and the area around
your vehicle when predictive control is
switched on. The driver is always responsible
for assessing the traffic situation.
~The system does not consider “right of way”
rules and does not respond to traffic lights,
so lack of driver attention in these situations
can increase the risk of an accident.
~The speed when driving through curves may
be different from what you as a driver would
129
OwnersManuals2.com