Audi Q4 e-tron 2024 - Page 52

Lights and vi
does not affect the service life of the light-
ing.
—When the parking lights are switched on
and the ignition is switched off, the Bq sym-
bol appears in the light switch module.
Turn signal and high beam lever
Fig. 38 Operating lever: switching the light functions on
and off
The lever operates the turn signals, the high
beams and the headlight flasher.
Turn signals © >>
The turn signal will activate when you move the
lever into a turn signal position while the ignition
is switched on. The respective KM] or Ej indicator
light will flash. The turn signal blinks three times
if you tap the lever (convenience turn signal).
@ Right turn signal
@ Left turn signal
If an indicator light blinks twice as fast as usual,
a turn signal bulb has failed. Carefully drive to an
authorized Audi dealer or authorized Audi Service
Facility immediately to have the malfunction cor-
rected.
High beams £O and headlight flasher
» Move the lever to the corresponding position:
@High beams on (vehicles with High beam as-
sistant* > page 50)
@®High beams off or headlight flasher
The Ef indicator light in the instrument cluster
will turn on.
D_ Not available in all countries.
50
High beams can cause glare for other persons,
which increases the risk of an accident. For
this reason, only use the high beams or the
headlight flasher when they will not create
glare for other drivers.
High beam assistant
Applies to: vehicles with high beam assistant
The high beam assistant automatically turns the
high beams on or off depending on the surround-
ing conditions.
Acamera on the rearview mirror mount can de-
tect light sources from other road users. The high
beams switch on or off automatically depending
on the position of vehicles driving ahead and on-
coming vehicles, the vehicle speed as well as oth-
er environmental factors and traffic conditions.
Applies to: vehicles with Matrix LED headlights:
With Matrix LED headlights "), individual seg-
ments of the high beams are turned on or off.
The area in front of the vehicle is dimmed, while
the remaining area is illuminated. This allows for
optimal lighting of the surrounding area without
causing glare for other road users.
Activating high beam assistant #2
Requirement: the AUTO light function must be
selected and the high beam assistant must be
switched on in the MMI = page 57.
» To activate the high beam assistant, tap the
lever forward @) > page 50, fig. 38. The fay in-
dicator light will appear in the instrument clus-
ter display and the high beams will be switched
on or off automatically. If the high beams were
completely or partially switched on, the fig in-
dicator light will turn on.
Activating and deactivating the high beam
head lights manually
If the high beams did not switch on or off as ex-
pected, you may switch them on or off manually
instead: >
OwnersManuals2.com