Audi Q4 e-tron 2024 - Page 53

89401272186.
Lights and vision
> To activate the high beams manually, tap the
lever forward @) page 50, fig. 38. The Ejin-
dicator light will turn on.
» To deactivate the high beams manually, pull
the lever back @ page 50, fig. 38. The high
beam assistant is deactivated.
Operating the headlight flasher
» To operate the headlight flashers, pull the lever
back @ *page 50, fig. 38. If the high beam
headlights are not switched on, the high beam
assistant will remain activated.
— Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras > page 129 to > page 132.
—High beam assistant is only intended to as-
sist the driver. The driver is always responsi-
ble for controlling the high beam headlights
and adjusting them based on the lighting
and visibility conditions.
—High beams can cause glare for other per-
sons, which increases the risk of an accident.
For this reason, only use the high beams or
the headlight flasher when they will not cre-
ate glare for other drivers.
Adhere to any local applicable regulations
when using the lighting equipment, for exam-
ple in regard to reducing glare for other road
users. The driver is always responsible for ad-
hering to the regulations applicable in the
country where the vehicle is being operated.
Adjusting the exterior lighti
The following settings depend on the vehicle
equipment.
> Applies to: MMI: Select on the home screen:
VEHICLE > Light & Visibility > Exterior light-
ing.
»
is function was still in development at the time of print-
ing.
Automatic headlights
You can adjust the following settings in the Auto-
matic headlights menu:
Activation time - You can adjust if the headlights
switch on Early, Medium, or Late based on the
sensitivity of the light sensor 1),
High beam assistant - You can switch the high
beam assistant on and off.
Entry/exit lighting
The Entry/exit lighting illuminates the area
around the vehicle when the vehicle is unlocked
or when the driver's door is opened while the ig-
nition is off. The entry/exit lighting works when it
is dark and when the AUTO light function is
switched on. The daytime running lights switch
on automatically within the limits of the system
each time the vehicle is unlocked, regardless of
how bright it is outside the vehicle.
Daytime running lights
USA models: The daytime running lights can be
switched on and off.
Canada models: This function cannot be switched
off. They activate automatically each time the ig-
nition is switched on.
Digital light signatures
You can choose from different light signatures,
such as Light Design. The light signature is al-
ways active when the daytime running lights or
the parking lights are active.
Ifyou change to a different light signature, the
change will go into effect shortly after you exit
the vehicle.
51
OwnersManuals2.com