Audio Technica AT-LP120-USB User Manual

Setting up your PC (with Windows XP) to work with your USBTurntable
5. Next, select the Audio tab.
•
In the Sound playback area of the window, select your computer's internal
sound card.
•
In the Sound recording area of the window, select USB Audio CODEC.
• Check the following box: Use only default devices.
• Click Apply; then click OK.
Sounds and Audio Devices Properties i'?lrx
Volume
S Iqma Tel ,c.,udio
Audio
Hardware
[ ....... __ Vo_lu_m_e_ ... ~~. J[ Advanced... ]
Sound recording
D ef ault device:
I USB Audio CODEC
\/olume ...
MIDI music playback
~ Default device:
ti!I1!!f!1!) I Microsoft GS Wavetable SW Synth
,6,dvanced ...
["-_V_o_lum_e_.,, J[ Ab_o_ut_ ... J
~ Use only default devices
10
,
OK
~ [ Cancel ] ( Apply

Audio Technica AT-LP120-USB Specifications

General

Interface	USB, Analog
Signal-to-Noise Ratio (SNR)	50 dB
AC adapter frequency	50/60 Hz
AC adapter input voltage	115 - 230 V
Power consumption (typical)	11 W

Weight and Dimensions

Weight	10700 g
Product dimensions (WxHxD)	450 x 352 x 157 mm