- 37 -
7.11 Configuring IP Groups
This section describes configuring IP Groups. The IP Group represents an IP entity on the network
with which the SBC communicates. This can be a server (e.g., IP PBX or ITSP) or it can be a group of
users (e.g., LAN IP phones). For servers, the IP Group is typically used to define the server's IP address
by associating it with a Proxy Set. Once IP Groups are configured, they are used to configure IP-to-IP
routing rules for denoting source and destination of the call.
In this typical deployment topology, IP Groups must be configured for the following IP entities:
◼ ZPLS Module
◼ Zoom Phone Cloud System
◼ Generic SIP Trunk
To configure IP Groups:
1. Open the IP Groups table (Setup menu > Signaling & Media tab > Core Entities folder > IP
Groups).
2. Configure an IP Group for the ZPLS Module:
To Next Page
Loading...
Need help?
General
