Survivable Branch Appliance
AudioCodes Enhanced Media Gateway 92 Document #: LTRT-18206
Parameter Description
Source IP Source IP address of the caller (obtained from the Contact header in the
INVITE message).
Notes:
This parameter is applicable only to the Number Manipulation tables for
IP-to-Tel calls.
The source IP address can include the 'x' wildcard to represent single
digits. For example: 10.8.8.xx represents all IP addresses between
10.8.8.10 to 10.8.8.99.
The source IP address can include the asterisk (*) wildcard to represent
any number between 0 and 255. For example, 10.8.8.* represents all IP
addresses between 10.8.8.0 and 10.8.8.255.
Stripped Digits From Left Number of digits to remove from the left of the telephone number prefix. For
example, if you enter 3 and the phone number is 5551234, the new phone
number is 1234.
Stripped Digits From Right Number of digits to remove from the right of the telephone number prefix.
For example, if you enter 3 and the phone number is 5551234, the new
phone number is 5551.
Prefix to Add The number or string that you want added to the front of the telephone
number. For example, if you enter '9' and the phone number is 1234, the
new number is 91234.
Suffix to Add The number or string that you want added to the end of the telephone
number. For example, if you enter '00' and the phone number is 1234, the
new number is 123400.
Number of Digits to Leave The number of digits that you want to retain from the right of the phone
number.
NPI The Numbering Plan Indicator (NPI) assigned to this entry.
[0] Unknown (default)
[9] Private
[1] E.164 Public
[-1] Not Configured = value received from PSTN/IP is used
Notes:
This parameter is applicable only to Number Manipulation tables for IP-
to-Tel calls.
For a detailed list of the available NPI/TON values, refer to 4.10.3 on
page 94.
TON The Type of Number (TON) assigned to this entry.
If you selected 'Unknown' for the NPI, you can select Unknown [0].
If you selected 'Private' for the NPI, you can select Unknown [0], Level 2
Regional [1], Level 1 Regional [2], PISN Specific [3] or Level 0 Regional
(Local) [4].
If you selected 'E.164 Public' for the NPI, you can select Unknown [0],
International [1], National [2], Network Specific [3], Subscriber [4] or
Abbreviated [6].
Notes:
This parameter is applicable only to Number Manipulation tables for IP-
to-Tel calls.
The default is 'Unknown'.
To Next Page
Loading...
Need help?
General
