Audix RAD-360 - Setting Up the RAD-360 Receiver; Connecting Receiver Power Supply; Connecting Receiver Antennas

9
Setting up the Receiver
Connecting Power:
Begin by looping POWER CABLE through STRAIN RELIEF (g. 1). This will
prevent cable from being pulled from socket during operation. Plug POWER
CABLE into POWER SOCKET (g. 2). Connect to power source.
g. 1 g. 2
Connecting Antennas:
Line slots on ANTENNA up with ANTENNA BNC SOCKET on back of unit (g.
3). Push ANTENNA on and twist clockwise to lock using knurled section of
ANTENNA (g. 4).
g. 3 g. 4