AUMA SA Series Manual

2. Application and validity
2.1. Range of application
AUMA actuators and actuator controls in SIL version are intended for operation of
industrial valves and are suitable for use in safety instrumented systems in accordance
with IEC 61508 or IEC 61511.
2.2. Standards
Both actuators and actuator controls meet the following requirements:
●
IEC 61508 ED.2: Functional safety of electrical/electronic/programmable elec-
tronic safety-related systems
2.3. Valid device types
The data on functional safety contained in this manual applies to the device types
indicated hereafter.
Table 2: Overview on suitable device types
Power supplyType
MotorControlsActuator
3-phase AC currentAC 01.2 in SIL versionSA 07.2 – SA 16.2
3-phase AC currentAC 01.2 in SIL versionSAR 07.2 – SAR 16.2
3-phase AC currentACExC 01.2 in SIL versionSAEx 07.2 – SAEx 16.2
3-phase AC currentACExC 01.2 in SIL versionSAREx 07.2 – SAREx 16.2
6
Multi-turn actuators
Application and validity SA 07.2 – SA 16.2/SAR 07.2 – SAR 16.2

AUMA SA Series Specifications

General

Torque range	10 Nm to 32, 000 Nm
Protection class	IP68
Ambient temperature	+70°C
Voltage	24V DC
Communication	PROFIBUS DP, MODBUS RTU, Foundation Fieldbus
Certifications	ATEX, IECEx, CSA, GOST, SIL
Control	Local, Remote, Bus (PROFIBUS, MODBUS)