AUMA SA Series Manual

NOTICE for use!
This document is only valid in combination with the current operation instructions enclosed with the device.
Purpose of the document:
The present documents informs about the actions required for using the device in safety-related systems in
accordance with IEC 61508 or IEC 61511.
Reference documents:
●
Operation instructions (Assembly, operation, commissioning) for actuator
●
Manual (Operation and setting) AUMATIC AC 01.2
●
Manual (Device integration Fieldbus) AUMATIC AC 01.2/ACExC 01.2
●
Technical data on multi-turn actuator and on actuator controls
Reference documents can be downloaded from the Internet (www.auma.com) or ordered directly from AUMA
(refer to <Addresses>).
Table of contents Page
41. Terminology............................................................................................................................
41.1. Abbreviations and concepts
62. Application and validity.........................................................................................................
62.1. Range of application
62.2. Standards
62.3. Valid device types
73. Architecture, configuration and applications......................................................................
73.1. Architecture (actuator sizing)
83.2. Configuration (setting)/version
93.3. Applications (environmental conditions)
114. Safety instrumented systems and safety functions...........................................................
114.1. Safety instrumented system including an actuator
114.2. Safety functions
124.3. Safe inputs and outputs
124.4. Redundant system architecture
134.5. Examples of applications
144.6. System representation
155. Installation, commissioning and operation.........................................................................
155.1. Installation
165.2. Commissioning
175.3. Operation
175.4. Lifetime
175.5. Decommissioning
186. Indications on display............................................................................................................
186.1. Status indications on SIL functions
196.2. SIL configuration warning
196.3. Backlight
207. Signals.....................................................................................................................................
207.1. Signals via SIL module
207.2. SIL fault signal via standard controls display (for troubleshooting support)
2
Multi-turn actuators
Table of contents SA 07.2 – SA 16.2/SAR 07.2 – SAR 16.2

AUMA SA Series Specifications

General

Torque range	10 Nm to 32, 000 Nm
Protection class	IP68
Ambient temperature	+70°C
Voltage	24V DC
Communication	PROFIBUS DP, MODBUS RTU, Foundation Fieldbus
Certifications	ATEX, IECEx, CSA, GOST, SIL
Control	Local, Remote, Bus (PROFIBUS, MODBUS)