AUMA SA3-SA100 - Default Chapter; Table of Contents

2
Table of Content
Sl. No.
Content
Page No.
1
Safety Instructions
3-6
1.1
Basic information on safety
1.2
Range of application
1.3
References and symbols
1.4
Name plate
1.5
Transport, storage and packaging
2
Introduction
7-10
3
Front panel details
11-14
3.1
Selector switch
3.2
LCD screen & LED indication
4
Modes of operation
15-38
4.1
Program mode
4.1.1
EDIT/VIEW option of program mode
4.1.2
EDIT mode parameters
4.1.3
Remote settings
4.1.4
Relay settings
4.1.5
Intermediate position setting
4.2
Diagnostic mode
4.3
Calibration mode
4.3.1
Limit open calibration
4.3.2
Limit close calibration
4.3.3
Close limit and open limit calibration through counter gears/ limit switches
4.3.4
Setting of Mechanical position indicator
4.3.5
Do's and Don'ts - Troubleshooting tips
4.3.6
Change torque trip value
4.3.7
Preset torque
5
Annexure
39-44
6
Disposal and recycling
45
Table of Content
Sl. No.
Content
Page No.
1
Safety Instructions
6-7
1.1
Basic information on safety
1.1.1
Safety instructions/warnings
8
1.1.2
Warnings and notes
1.1.3
Transport, storage and packaging
1.1.4
Qualification of staff
1.1.5
Commissioning
9-13
1.1.6
Operation
1.1.7
Protective measures
1.1.8
Maintenance
1.2
Range of application
1.3
References and symbols
1.3.1
Name plate
2
Introduction
17-17
2.1
LCD graphical display & LED indication
2.2
Inbuilt front panel option selection
2.3
Interfaces
2.4
Emergency stop - ESD
2.5
Event storage & data logging option
2.6
Partial valve stroke test (PVST) option
2.7
Inhibit option
18-20
2.8
Local control station (LCS) priority
2.8.1
Remote local stop
2.8.2
Timer mode
2.8.3
Programmable relays
2.8.4
Real time clock (RTC)
2.8.5
Power supply
Weather proof actuators with 3.XMP-SIL &
Data logging