Figure 12: Mounting positions C and D
4.5.1 Mounting positions: modify
Flameproof enclosure, danger of explosion!
Risk of death or serious injury.
→
Before opening, ensure that there is no explosive gas and no voltage.
→
Handle cover and housing parts with care.
→
Joint surfaces must not be damaged or soiled in any way.
→
Do not jam cover during fitting.
1. Loosen screws and remove the local controls.
2. Loosen 3 screws of the board, turn board to the new position and fasten the
screws.
3. Check whether O-ring is in good condition, correctly insert O-ring.
4. Turn local controls into new position and re-place.
Cable damage due to twisting or pinching!
Risk of functional failures.
→
Turn local controls by a maximum of 180°.
→
Carefully assemble local controls to avoid pinching the cables.
5. Fasten screws evenly crosswise.
16
SAExC 07.1 – SAExC 16.1/SARExC 07.1 – SARExC 16.1
Assembly AMExB 01.1
To Next Page
Loading...
