To Next PageTo Next Page
Need help?Do you have a question about the AUMA SAExC 16.1 and is the answer not in the manual?
General| Size | 16.1 |
|---|---|
| Protection Class | IP68 |
| Type of control unit | AUMATIC |
| Type | SAExC |
| Control Signal | 4-20 mA, digital |
| Output Signal | 4-20 mA, digital |
| Type of actuator | Multi-turn actuator |
| Ambient Temperature | -25°C to +60°C |
Essential safety precautions and general guidelines for safe operation.
Explains signal words (DANGER, WARNING, CAUTION, NOTICE) and warning structure.
Procedures for mounting the actuator onto valves or gearboxes.
Crucial safety information and general guidelines for electrical connections.
Detailed steps for connecting cables using screw-type terminals.
Detailed steps for connecting cables using spring cage terminals.
Procedures for engaging and disengaging manual operation using the handwheel.
How to operate the actuator via local controls or remote signals.
Using push buttons and selector switch for local control of the actuator.
Operating the actuator remotely via fieldbus or analogue setpoints.
Procedure for checking and setting valve seating modes (limit or torque).
How to check and set the torque switching parameters for valve protection.
Steps to set the actuator's limit switches for OPEN and CLOSED positions.
Configuration of the Profibus DP slave address for device communication.
Performing essential test runs after commissioning.
Troubleshooting common faults encountered during initial setup.
Understanding fault and warning messages displayed by the actuator.
Interpretation of fault and warning indicators in status display S0.
Detailed information on specific fault indications (e.g., torque, phase loss).
Explanation of warning messages displayed by the actuator.
Identifying reasons why the actuator is not ready for remote operation.
Routine checks and maintenance tasks to ensure safe operation.
