AUMA SAR 07.6 - Menu Layout and Navigation

2.
Press Up ▲to select a higher user level and press Ok to confirm.
➥
Display shows: Password 0***
3.
Use push buttons Up ▲ Down ▼ to select figures 0 to 9.
4.
Confirm first digit of password via push button Ok.
5. Repeat steps 1 and 2 for all further digits.
➥
Having confirmed the last digit with Ok, access to all parameters within one
user level is possible if the password entry is correct.
6.4.2. Password change
Only the passwords of same or lower user level may be changed.
Example:The user is signed in as Specialist (4).This authorises him or her to modify
the passwords between user levels (1) to (4).
Device configuration M0053
Service functions M0222
Change passwords M0229
Menu point Service functions M0222 is only visible if user level has been set to
Specialist (4) or higher.
Select main menu
1. Set selector switch to position 0 (OFF).
2.
Press push button C Setup and hold it down for approx. 3 seconds.
➥
Display goes to main menu and indicates: ▶ Display...
Change passwords
3.
Select parameter Change passwords either:
→
click via the menu to parameter, or
→
via direct display: press and enter ID M0229
-
Display indicates: ▶ Change passwords
- The user level is indicated in the top row (1 – 6), e.g.:
- For user level 1 (view only), passwords cannot be changed. To change pass-
words, you must change to a higher user level. For this, enter a password via
a parameter.
4.
For a user level between 2 and 6: Press push button Ok.
➥
The display indicates the highest user level, e.g.: For user 4
5.
Select user level via push buttons Up ▲ Down ▼ and confirm with Ok.
➥
Display indicates: ▶ Change passwords Password 0***
6.
Enter current password (→ enter password).
➥
Display indicates: ▶ Change passwords Password (new) 0***
7.
Enter new password (→ enter password).
➥
Display indicates: ▶ Change passwords For user 4 (example)
8.
Select next user level via push buttons Up ▲ Down ▼ or cancel the process
via Esc.
6.5. Language in the display
The AUMATIC actuator controls display is multilingual.
42
SA 07.2 – SA 16.2/SAR 07.2 – SAR 16.2 Control unit: electronic (MWG)
Operation AC 01.2 Non-Intrusive HART