To Next PageTo Next Page
Need help?Do you have a question about the AUMA SAREx 07.6 and is the answer not in the manual?
General| Brand | AUMA |
|---|---|
| Model | SAREx 07.6 |
| Category | Controller |
| Language | English |
Ensures compliance with regulations for assembly, electrical connection, commissioning, and operation.
Explains safety-relevant procedures and signal words (DANGER, WARNING, CAUTION, NOTICE).
Defines multi-turn actuators and describes AUMA's SAEx/SAREx models.
Step-by-step guide for attaching actuators to valves, including output drive types.
Covers safety warnings, wiring diagrams, and permissible network types.
Overview of KT/KM, KP/KPH, and KES electrical connection versions.
Describes how to operate the actuator manually using the handwheel.
Explains how to operate the actuator using the push buttons on the control unit.
Explains status bar, navigation support, and feedback signals like valve position.
Procedure for setting the valve seating type (limit or torque).
Configuration of Modbus address, baud rate, parity, and monitoring time.
Instructions for setting torque switching and limit switches for end positions.
Steps for performing test runs, checking rotation direction, and limit switching.
Troubleshooting common faults encountered during commissioning.
Procedures for disconnecting the actuator from power for maintenance.
