auronic AU3265 - Page 63

English
63
If you turn this feature on, after fully charging, the robot will return
to the last point where it left off cleaning, and continue. If you
turn this feature off, the robot will start cleaning again after fully
charging.
1. Tap “Settings > Continue cleaning at breakpoint”.
2. The robot gives a voice notication “I continue where I ended
the previous cleaning” or “I stop where I ended the previous
cleaning.” If the box is blue, the function is on. If the box is gray,
the function is off.
3.9.15 Setting the unit of measurement
You can set the desired unit of measurement in the app. You can choose between “m2” and
“ft2”.
1. Tap “Settings > Unit”. Tap the desired unit of
measurement.
2. The selected unit of measurement is
automatically saved when tapping. A blue
check mark appears next to the selected unit of
measurement.
3.9.16 Product information
In the app you can view the technical data of the robot. You cannot adjust this data manually.
The data will be updated automatically when
changes are made to the product by, for example, a
rmware update.
Tap “Settings > Device info”.
3.9.17 Setting suction power and water ow
rate
You can set the water ow rate and
suction power in the app. Both can be set in three
ways.
1. Tap “Cleaning Preference”.
2. At “Water volume adjustment” you can set the water volume
by tapping the desired position:
• Closed: no water output
• Low: low water volume
• Middle: normal water volume
• High: high water volume
1
1
1 3