Aurora AOne - Hub Network Configuration; Which ports need to be open for the AOne Hub?; How to remove; unpair Hub from an Account?

28
Which ports need to be open to use the AOne Hub?
If your AOne Hub is displaying a Red Exclamation Mark ! it could be pointing to an Internet
Connection issue that could be caused by your Internet Router blocking access to the Hub.
For the AOne Hub to work correctly, the following ports need to be open in your router firewall:
UDP Ports 5560 - 5566
TCP Port 5568
TCP/UDP Port 8883
Please allow inbound and outbound traffic.
If your router firewall restricts access to these ports, you will need to update your firewall settings
before you can use the AOne Hub and perform a Port Forward on the Internet Router.
For comprehensive instructions on using your firewall and updating your settings, please refer to your
Router manufacturer’s or Internet Service Provider's website.
How to remove / unpair Hub from an Account?
Method 1:
On the main page, tap the Hub icon in the Top Left
Press and hold on the Hub you want to remove
Press Yes to Remove the Hub from the Account
Method 2:
Go to the Set up Devices page
Tap the Hub's name
Tap Remove / BIN Icon
Tap Yes to Remove the Hub from the Account
How do I swap between Hubs on my account?
1. Tap the Hub icon or Hub name in the top left corner of the main screen
2. Tap the Hub you want to connect to
3. Wait a few seconds to fully connect and use your System
Note - You cannot connect to a Hub that is currently not powered on or connected to the Internet.