AUTEC A08 - Technical Specifications and Data Sheet; Unit Technical Data; Technical Data Sheet Usage

4 Technical data
Power supply (battery LPM00) ............................................................................... 3.7V
Antenna .................................................................................................................. internal
Housing material .......................................................................................... PA 6 (20%fg)
Protection degree ....................................................................................... IP65 (NEMA 4)
Dimensions ............................................................ 64.5x179x37.5mm (2.54x7.05x1.48In)
Weight ......................................................................................................... 250g (0.55Lb)
Run time at 20°C (68°F) .............................................................................................. 16h
Maximum altitude (a.s.l.) ......................................................................................... 2000m
Continuous vibration ..................................................................... 0.35mm, 5g (10-150Hz)
Shock ................................................................................................. half sine, 11ms, 30g
Fall ...................................................... 2 falls from a height of 1m onto a concrete surface
Power frequency magnetic 󰘰eld immunity according to CEI EN 61000-4-8 ... up to 300A/m
5 Technical Data Sheet
The Radio Remote Control 's Technical Data Sheet:
- describes the Transmitting Unit's con󰘰guration,
- indicates the relation between commands sent by the Transmitting Unit and those available
on the Receiving Unit.
The Technical Data Sheet must be 󰘰lled in, checked and signed by the Installer, who is
responsible for correct wiring.
A Technical Data Sheet must always be kept together with this Manual: if you need to use
the Technical Data Sheet for administrative purposes (tests, check, etc.), make a copy of it.
The wiring of the Receiving Unit's outputs must always re󰄉ect the wiring
indicated in the Technical Data Sheet.
AUTEC - Air series
Technical data 13
LIUA8BEN0_eng-01