8.7.3 Procedure to modify the PIN code
If a PIN code is needed for the Transmitting Unit, it can be modied to limit the use of the
Radio Remote Control.
To modify the PIN code, perform the following procedure with the Transmitting Unit switched
o and the STOP pushbutton released.
1. Press pushbuttons FUNCTION and START and hold them down until the green LED
blinks (1 blink per second).
2. Enter the PIN code sequence provided in the Technical Data Sheet.
3. Press pushbutton S1 (see Technical Data Sheet) repeatedly until LED 2 illuminates.
4. Press pushbutton S2 (see Technical Data Sheet) to conrm your selection (green LED
blinks twice per second). You can choose the 3 pushbuttons you want to set as PIN code
amongst all the pushbuttons on the Unit. If you want to start the Radio Remote Control with:
- single-pushbutton PIN code: press the START pushbutton as PIN 1 and PIN 3;
- two-pushbutton PIN code: press the START pushbutton as PIN 1 or PIN 3.
5. Press the pushbutton you want to allocate as PIN 1 (LED 1 and green LED are steady on).
6. Press the pushbutton you want to allocate as PIN 2 (LED 2 and green LED are steady on).
7. Press the pushbutton you want to allocate as PIN 3 (LED 3 and green LED are steady
on). PIN code is saved automatically.
8.8 Command activation
When the Radio Remote Control is started, it is possible to activate movements, functions
and commands on the Machine by acting on the related pushbuttons, whose functions and
symbols are decided by the Manufacturer and/or the Installer. To identify the relation between
the pushbuttons and the corresponding Machine movements, the Machine Manufacturer
and/or the Installer shall provide relevant instructions and the User shall be properly trained.
8.9 Radio link interruption
When the radio link is incorrect or interrupted, the automatic stop function activates (see
paragraph "Control devices" in the Instruction Manual's general part).
The green LED on the Transmitting Unit switches from blinking slowly to blinking fast , steady
on, repeats the sequence: two blinks and a pause or three blinks and a pause (see chapter 11).
8.10 Transmitting Unit automatic switch o
The Transmitting Unit automatically switches o when:
- the battery is at (see paragraph 8.10.1),
- the Radio Remote Control is not used for a certain time (see paragraph 8.10.2).
To start the Radio Remote Control, see paragraph 8.7.
24
LIUA8BEN0_eng-01
General operating instructions
AUTEC - Air series
To Next Page
Loading...
