AUTEC A08 - Control Functions and Battery Management; FUNCTION Pushbutton; Battery Insertion Procedure

8.4 FUNCTION pushbutton
The function of the FUNCTION pushbutton is decided by the Installer of the Radio Remote
Control. The Machine Manufacturer and/or the Installer must provide the user with instructions
about the relation between the FUNCTION pushbutton and the corresponding movement on
the Machine. The User must be properly trained about this.
8.5 Battery
The Air series' Transmitting Units can only be powered by Autec rechargeable
batteries.
For any warnings and instructions regarding the battery, see "Part E" in
the Instruction Manual.
8.5.1 Battery insertion
Push the battery towards the contacts on the Transmitting Unit (1) and insert it inside the
housing (2).
1
2
The battery slides in with no e󰘯ort and ensures the correct connection of the positive
(+) and negative (-) poles only if it is inserted as shown in the above pictures.
AUTEC - Air series
General operating instructions 19
LIUA8BEN0_eng-01