8.5.2 Battery removal
Push the battery towards the contacts on the Transmitting Unit (3) and remove it from the
housing (4).
When the Transmitting Unit is not in use, remove the battery if possible.
8.5.3 Indication of the battery charge level
Perform the following actions to check the Transmitting Unit's battery
charge level:
1. Switch off the Transmitting Unit and make sure that the STOP
pushbutton is unlocked.
2. Hold down pushbuttons S1 and START until the 3 LEDs on the left
hand side illuminate showing the Unit's charge level (3 illuminated
LEDs=maximum charge level). The charge level indication disappears
after some seconds.
Commands associated to the keys that are activated during the procedure to
check the battery charge level are not sent to the Machine.
20
LIUA8BEN0_eng-01
General operating instructions
AUTEC - Air series
To Next Page
Loading...
