8.7 Starting up the Radio Remote Control
Starting up the Radio Remote Control consists in establishing a radio link between the
Transmitting Unit and the Receiving Unit.
The Radio Remote Control start up is protected by means of a
power keyswitch to prevent unauthorised use of the machine.
If the risk assessment requires further protection during the Radio Remote
Control start up, the Machine Manufacturer and/or the Radio Remote Control
Installer can enable the PIN code too.
Autec will enable the PIN code for the Radio Remote Control start up only
upon request by the Machine Manufacturer and/or the Radio Remote Control
Installer.
To start up the Radio Remote Control, you need to insert the power keyswitch
and key in the PIN code (if any) according to the procedures indicated in
paragraph 8.7.1 or 8.7.2.
The PIN code is not a sequence of numbers, but it consists in the sequential activation of
pushbuttons.
Commands associated with the pushbuttons that are activated while typing the
PIN code are not sent to the Machine.
8.7.1 Power keyswitch start up (no PIN code)
When the Receiving Unit is powered on correctly, perform the following procedure:
1. Insert a charged battery in the Transmitting Unit (see paragraph 8.5.1),
2. insert the power keyswitch in the Transmitting Unit,
3. press the START pushbutton and hold it down until the green LED blinks quickly.
4. release the START pushbutton.
When the green LED blinks slowly, the Radio Remote Control is active and it can send
commands and activate the Machine.
22
LIUA8BEN0_eng-01
General operating instructions
AUTEC - Air series
To Next Page
Loading...
