8.12 "Data Feedback" function
The User receives information and/or signals concerning some particular situations and the
movements of the controlled Machine by means of the "Data Feedback" function.
The "Data Feedback" function works with LEDs: specic Machine conditions (e.g. load limits,
limit switch) may be signalled by the illumination of the LEDs. The signalled conditions depend
on the settings chosen by the Person who installed the Radio Remote Control on the Machine.
Pay particular attention to LED indications during normal Radio Remote Control operation:
they can be helpful to evaluate the Machine's working status.
Any information signalled by LEDs for the "Data Feedback" function can
never be considered or used as a safety signal or for legal metrology.
When operating and moving the Machine, remember that the Radio Remote
Control does not intervene autonomously when potential hazardous
situations are signalled.
If the green LED repeats the sequence "three blinks and a pause", there is no
information and/or signals coming from the "Data Feedback" function. In this
case, bring the Transmitting Unit closer to the Receiving Unit until the green
LED blinks slowly.
26
LIUA8BEN0_eng-01
General operating instructions
AUTEC - Air series
To Next Page
Loading...
