8 General operating instructions
8.1 Power keyswitch
The Transmitting Unit always has a power keyswitch that allows to power the Unit.
The Radio Remote Control cannot work if the power keyswitch is not inserted in the Transmitting
Unit.
Power keyswitch
8.2 START pushbutton
The START pushbutton is used to:
- start the Radio Remote Control (see paragraph 8.7),
- activate the horn when the Radio Remote Control is started.
8.3 STOP pushbutton
When the STOP pushbutton is activated, the Machine stops and the Transmitting Unit switches
o. To start the Radio Remote Control again and enable it to control the Machine after the
STOP pushbutton has been pressed, you need to:
- make sure that the working and usage conditions are safe,
- pull or turn the STOP pushbutton in the arrow direction (show on the button) to unlock it,
- start the Radio Remote Control following the procedure described in paragraph 8.7.
The STOP pushbutton should be pressed when it is necessary to stop the
Machine immediately whenever a dangerous condition occurs.
The Machine Manufacturer and/or the Installer must provide the User with the
instructions and warnings concerning possible risks that may originate from
the Machine stop (by way of example: movement inertia, swinging load…).
18
LIUA8BEN0_eng-01
General operating instructions
AUTEC - Air series
To Next Page
Loading...
