2
NeoSlider
TM
- Sliding Gate Opener NES-24V3 Owner Installation Instructions
Automatic Technology Australia Pty Ltd to the extent that such may be lawfully excluded hereby expressly disclaims all conditions or warranties, statutory
or otherwise which may be implied by laws as conditions or warranties of purchase of an Automatic Technology Australia Pty Ltd Garage Door Opener.
Automatic Technology Australia Pty Ltd hereby further expressly excludes all or any liability for any injury, damage, cost, expense or claim whatsoever
suffered by any person as a result whether directly or indirectly from failure to install the Automatic Technology Australia Pty Ltd Garage Door Opener in
accordance with these installation instructions.
NeoSlider
TM
Sliding Gate Opener NES-24V3
Contents
1. Important Safety Instructions 3
2. Control Board Layout 4
3. Set Up Requirements 5
3.1 Kit Contents 5
3.2 Choosing your Set up 5
4. Drive Unit Installation 6
4.1 Initial Checking 6
4.2 Mounting the Drive Unit 6
4.3 Installing antenna 6
5. Rack & Limit Actuator Installation 7
5.2 Fixing limit actuator to rack 7
5.1 Mounting rack to gate 7
6. Programming The NeoSlider
TM
8
6.1 Common Programs 8
6.2 Powering up the NeoSlider
TM
8
7. Safety Beams 9
7.1 Installation of Safety Beams to the NeoSlider
TM
9
7.2 Safety Beam Failure Emergency Close (SBFEC) 9
8. Setting Limits 10
8.1 Setting Travel Limits 10
8.2 Setting the left/right installation side settings 10
8.3 Setting close travel limit 10
8.4 Setting open travel limit 10
8.5 Automatic limit adjustment and load profile 11
8.6 Pedestrian access position 11
8.7 Errors during setting of travel limit 11
9. Safety Obstruction Force Test 12
9.1 Testing Close Cycle 12
9.2 Testing Open Cycle 12
9.3 Force Pressure For Close and Open Cycle. 12
9.4 Reprofiling Travel 12
10. Coding Transmitter 13
10.1 Coding Transmitter Button 13
10.2 Selecting Function Of The Button 13
10.3 Returning To Main Screen 13
11. Remotely Coding Transmitters 14
11.1 Selecting The Function To Be Coded 14
11.2 Activate Remote Code Set Mode 14
12. Battery Replacement 15
13. Battery Disposal 15
14. Setting Pedestrian Position 16
14.1 Setting pedestrian position 16
14.2 Pedestrian Position Set 16
14.3 Error Displays 16
15. Auto-Close Mode 17
15.1 Setting Up Standard Auto-Close 17
15.2 Safety Beam Triggered Auto Close 17
15.3 Pedestrian Auto-Close 17
15.4 Auto-Close After Obstruction 17
16. Accessories Installation 18
16.1 Fitting Solenoid Or Magnetic Locks 18
16.2 Fitting Courtesy Lights 18
17. Specifications 19
18. Troubleshooting 20
19. Appendix 21
A - Console Menu Structure 21
B - Viewing and Editing Parameters 23
C - Wiring Dual NeoSlider Kit 24
D - Control Board Adjustments 25
E- Diagnostic Tools 27
F - Memory Tools 28
G- Transmitter Editing 29
H- Transmitter Managment 31
20. Warranty and Exclusion of Liability 32
To Next Page
Loading...
