Automatic Technology SecuraLift GDO-7V1 - Remote Transmitter Storage; Deleting Transmitter Codes

Owner Installation Instructions GDO-7V1 SecuraLift®
21
Coding transmitters
27
fig
28
fig
Wall mount holder
Small needle
Coding hole
Step 19. Storing transmitter(s)
from a remote location
Using this method you don’t need to have access
to the control panel on the Door Opener. However,
you do need a transmitter that is pre coded to the
controller’s receiver.
IMPORTANT NOTE: The Door or Courtesy
Light must be activated when the step below is
performed. The moving Door or Light switching
on is to confirm from a remote location that, the
correct button was pressed, and the transmitter is
in range of the Opener.
1. Take any pre-coded transmitter. Press the button for
the function you require until the door is activated
and release.
2. Then using a small needle press and hold firmly for
two seconds through the Coding Hole (Fig. 27)
3. Within 10 seconds take the additional transmitter
you wish to code.
4. Press the button (one of four) on that transmitter
you would like to use to control the door for two
seconds, pause for two seconds. Press the same
button again on the transmitter for two seconds, the
button should now be recorded.
5. Wait for 10 seconds and then press the recorded
transmitter button to see if it operates the door.
20. Deleting programmed codes
20.1. Deleting a stored transmitter code
1. Select the transmitter you want to delete.
2. Press and hold the Door Code button (Fig. 28).
3. Press the transmitter button you would like to delete
for two seconds. Pause for two seconds. Press the
transmitter button again for two seconds.
4. Release the Door Code button. The code should now
be deleted. Confirm this by pressing the transmitter
button, the door should not respond.
20.2. Deleting all stored
transmitteCodes
1. Turn the Power Off to the Opener.
2. Press and hold the Door Code button (Fig. 28).
3. Turn the Power On again, while holding the Door
Code button. The Open Limit, Close Limit and Door
Status LED’s will illuminate for about five seconds.
These LED’s will turn Off and the Coding LED will
illuminate. Release the Door Code button. All the
stored codes including the Courtesy Light codes
should now be deleted. Confirm this by trying
to operate the door by pressing the transmitters
previously used to control the door, the door should
not respond.