EasyManua.ls Logo

Automatic Technology Syncro ATS-3 - Battery Replacement; Battery Disposal; Warranty

Automatic Technology Syncro ATS-3
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ATS Series Installation Manual22
22. After Installation Care
Warranty conditional on proper servicing as listed in 22.1 Service Checklist. Full details of the warranty are available in your
Owners Opener Handbook, from your nearest ATA office or visit the ATA Website ata-aust.com.au.
22.4 Warranty
When batteries reach the end of their usual life in accordance with Australian Battery Recycling Initiative please follow the next
simple steps for protecting the environment. Refer to the Automatic Technology website for information on where to recycle
batteries in Australia.
DO NOT throw the batteries in municipal waste. This symbol of the crossed out wheeled bin
indicates that the battery should not be placed in the municipal waste. Check your local regulations
for appropriate disposal of the batteries.
Recycling all batteries will have other environmental and social benefits:
WARNING! Prior to disposal, recycling, or collection, all battery terminals must be securely
insulated with a non conductive material to prevent any two batteries from short circuiting
and generating heat during storage or transport. Battery terminals may be insulated with
electrical tape; or batteries may be individually packaged in a non conductive material
(e.g., plastic bag or original packaging).
22.3 Battery Disposal
Battery Type:
3V Lithium Battery CR2032.
a. To test the battery is working, press and hold a transmitter
button. Check Light Status table to determine if battery
needs replacing
Light Status Battery Status
Solid OK
Flashing Requires replacement
No light Requires replacement
22.2 Battery Replacement
Use a pen
to push the
battery down
through the
side opening
to release
battery
b. Use a screwdriver to remove the screw on the back of the
transmitter casing.
c. Use the screwdriver to pry open the plastic to expose
circuit board.
d. With a non-metallic object (e.g. pen) remove the battery.
Some batteries are less toxic but hazardous for other reasons.
Lithium batteries can explode or catch fire in landfill, while button
cells are dangerous if swallowed by children. Recycling offers a
safe and environmentally responsible solution for end of life
batteries.
Battery recycling recovers non-renewable materials such as lead,
cadmium, stella, zinc, manganese, cobalt, silver, plastics and rare
earth elements.
Removal of batteries and other hazardous household products
from household waste facilitates the recovery of organic materials
through alternative waste technologies such as composting.
Batteries and heavy metals are known contaminants in compost.
The community supports recycling because it reduces waste to
landfill and achieves environmental benefits.
WARNING! Chemical Burn Hazard. Keep
batteries away from children
WARNING! The Battery shall be disposed of properly, including keeping them away from children.
Even used batteries may cause injury.

Table of Contents

Other manuals for Automatic Technology Syncro ATS-3

Related product manuals