Automationdirect.com HX-ECOM Series - Page 101

Ethernet Communications Modules, 3rd Edition, Rev. D
6-4
Chapter 6: H0/H2/H4-ECOM100 DHCP & HTML Configuration
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Ethernet Address: this is the MAC Address. It is a factory-assigned address that is on the
permanent label on the module.
IP Configuration: Set IP Address, Subnet Mask and Gateway addresses. Click the Send button
to write to the module flash memory.
The module’s current Booter Version and OS Version are listed. The latest versions can be
found by clicking Hosteng.com in the Firmware Updates field.
The module’s current CPU Rev and PWB/PLD Rev are listed. The latest versions can be found
by clicking Hosteng.com in the Firmware Updates field.
Firmware Updates: If your PC is connected to the internet, clicking on Hosteng.com will
take you to Host Engineering’s web site where the most current firmware files are available for
downloading to your PC. You must use NetEdit3.5 or later to upgrade the module.